Goodaye,
I've noticed in the AAR's that there are little 'signpost' on certain sections of railway track.
Would I be correct in assuming that the ownership of that track section is denoted by the flag at the top and the number indicates the number of corps that can use that section each turn, i.e the capacity of the track?
Cheers,
Plugger
You are correct! These signpost appear where the railline for a given power ends, usually because of being cut by advancing enemy. You need to turn on the "convert railroad" option for a stack moving through the area to have it connected to your rail network. Obviously it costs movement points so you dont want an entire army doing this. But it is crucial for your supply lines.
ctwino wrote:I have a stack siting in the region, have depressed the convert rails button, but for two turns running nothing happening. in fact so far in this game i havent had a railway converted yet
Usually I convert railroads while moving. I have a single unit stack moving separately, with railroad conversion turned on.
PhilThib wrote:Did you have a corps staying idle in the region while doing this? BTW, where was it (East or West Front)?
yes just ran a turn too. they were stationary. do they need to move thru the area? if so, any movement or do they have to start in my own area (say starting German province) and then into and thru a captured one?
West front, mutliple areas (stationary units)
Return to “WW1 : La Grande Guerre 14-18”
Who is online
Users browsing this forum: No registered users and 4 guests