AGEOD Forums

Just wondering if there was perhaps a chance to optionally allow this again? While PWR is definitely the mode that sees usage most of the time, its still nice to quickly at a glance see the number of men in your units. This is of course still possible by hovering over the PWR of the unit in question at the bottom of the screen, but I just felt that I had an easier 'workflow' by quickly selecting a stack, checking numbers by pressing CRTL and then proceeding from there.

The new interface (the one used in CW2) renders this harder to do, this is why we changed your habit

Ah, okay. It's just a minor issue that I will be getting used to no doubt.