Problem with 1812 scenario
Posted: Sat May 24, 2008 4:37 pm
I tried to play the 1812 scenario six times.
Every time the Russians ignored the Grand Army, scattered their armies into single Corps and Divisions, and ran them all west. There are almost no French/Allied troops in the west or south, so eventually all my supply lines were cut. Game over. [color="DarkRed"](Well, ok, a bit of an over statement. There were at least two large Russian armies. I destroyed the one around Vilnius. The other marched on Warsaw and supported the dozen or so independent corps/divisions. I had nothing to fight it with.)[/color]
Then I tried sliding the whole French army south and east from the area of Vilnius to prevent the Russians from sending their armies west, but the Russians just slid their armies south first and then west, breaking down into a dozen individual "stacks" of single divisions as before (Cav Divs & Inf Divs.) and individual corps, so eventually all my supply lines were cut. Game over.
Finally I gave up on the idea of advancing into Russia and tried the game again, running the whole Grand Army back west to fight in Poland. Russian Divisions actually traveled west faster than I did and I was effectively chasing them toward France. The whole thing was a farce. Game over.
Even when I get troops in front of the Russian Cavalry divisions they just run through me like I was not there. I even had infantry garrisons in my towns defeated by Russian cavalry units.
Do the Russians have supply restrictions? Do they have anything like command/control problems? The fact that the Entire Grand Army is deployed around Vilnius at the start of the game seems to cripple the scenario from the outset. Is there a way to change the starting French Deployment? Can you actually reach Moscow?
Every time the Russians ignored the Grand Army, scattered their armies into single Corps and Divisions, and ran them all west. There are almost no French/Allied troops in the west or south, so eventually all my supply lines were cut. Game over. [color="DarkRed"](Well, ok, a bit of an over statement. There were at least two large Russian armies. I destroyed the one around Vilnius. The other marched on Warsaw and supported the dozen or so independent corps/divisions. I had nothing to fight it with.)[/color]
Then I tried sliding the whole French army south and east from the area of Vilnius to prevent the Russians from sending their armies west, but the Russians just slid their armies south first and then west, breaking down into a dozen individual "stacks" of single divisions as before (Cav Divs & Inf Divs.) and individual corps, so eventually all my supply lines were cut. Game over.
Finally I gave up on the idea of advancing into Russia and tried the game again, running the whole Grand Army back west to fight in Poland. Russian Divisions actually traveled west faster than I did and I was effectively chasing them toward France. The whole thing was a farce. Game over.
Even when I get troops in front of the Russian Cavalry divisions they just run through me like I was not there. I even had infantry garrisons in my towns defeated by Russian cavalry units.
Do the Russians have supply restrictions? Do they have anything like command/control problems? The fact that the Entire Grand Army is deployed around Vilnius at the start of the game seems to cripple the scenario from the outset. Is there a way to change the starting French Deployment? Can you actually reach Moscow?
